[USG] Firmware v4.4.36 now available

UniFi

RSS Bot
UniFier
1 feb 2018
344
33
28
Only one change since v4.4.34, however an important one for some use cases.

  • Do not clear IPs from DHCP WAN interface in PREINIT of a forced renewal. The primary problem symptom is when the system is provisioned by the controller when booting up (most always only the first boot post-upgrade).

    In all firmware versions prior to this, that provisioning would remove the WAN IP then go through the DHCP lease process. This would leave a single WAN system with no Internet connectivity for a few seconds at least, and in multi-WAN cases, would cause a failover and fail back. In most cases, that was the only noticable symptom and it self-recovered without any problems, but in some it could cause issues that require another reboot post-upgrade. In multi-WAN cases, it could cause WAN to stay in a down state on the first bootup post-upgrade. In normal operation of the system, there are no forced DHCP renewals (this isn't relevant to the normal process of DHCP renewal).


Downloads



Hashes

  • USG
    • md5: 15e5f0e2b926fe1259556a096260fdba
    • sha256: c4eec3a41c45ab0f3a90c05e0902cedceece5c2e02cd6ee3a63e5450256e45c0
  • USG Pro
    • md5: 82e244e306045f4b81b4a311b30c3c03
    • sha256: cfab382991c712c561927a0bd5c302d17548e346b504f9450095129083b47d91
  • USG-XG-8
    • md5: 828b32f88efdb28be13ba1225c256da5
    • sha256: 16e72b1c9024afbc9dd2da2c27c719f514d22fef8aa3df051bfc52c45ef5f501


Verder lezen...
 
Activiteit
Er wordt op dit moment (nog) geen nieuwe reactie gepost.
  Topic Status: Hallo . Er is al meer dan 14 dagen geen nieuwe reactie meer geplaatst.
  De inhoud is mogelijk niet langer relevant.
  Misschien is het beter om in plaats daarvan een nieuw onderwerp te starten..