Overview
To upgrade to this version of UniFi Protect, you will need one of the following firmware versions (or newer):- UDM-Pro 1.10.4
- UDM-Pro-SE 2.2.4
- UDR 2.2.12
- UNVR / UNVR PRO 1.4.9
- UCK-G2-PLUS 2.1.11
Improvements
- Improve "Storage Utilization" information if no SD card is inserted on the UDR console.
- Improve Doorbell Ring notification delivery speed.
- Wireless Cameras: Improve connection stability.
- Web UI: Improve camera selection in the Playback section.
- Web UI: Pop out event thumbnail in the timeline when scrubbing.
- Web UI: Enable low battery notifications for IoT devices.
- AI-Bullet: Improve audio quality on far end pick up.
- G4-Doorbell-Pro: Enable the package camera light at night time for 15 seconds when live viewing the camera.
Bugfixes
- Fix issue where notification for hard disk failure is not sent.
- Fix issue where notifications are turned off in rare cases.
- Fix rare application crash.
- Fix issue where un-managing cameras causes application restarts.
- Fix issue where the camera does not always record when it's scheduled to record in rare cases.
- Web UI: Allow to pair only adopted cameras to DoorLock.
- Web UI: Add Earliest Recording date on hover over in Dashboard.
- Web UI: Fix issue where "(C)" overlaps Safe Zone in UP-Sense property panel.
- Web UI: Fix full-screen mode not preserving when switching between live views.
- Web UI: Fix issue where new user roles couldn't be saved.
- AI-360: Addresses stuttering playback.
- AI-360: Swap dewarp zoom scroll direction.
- Cameras: Fix issues were timezones cause issues.
- G4-PTZ: Fix issue where camera last position is not returned after device reboot.