Improvements
- Added support for Saved VPN profiles.
- Enhanced support for off-network WAN gateways.
- Improved auto recovery mechanism for Teleport.
- Improved WiFi Uplink roaming.
- Improved WiFi Uplink stability.
- Improved OpenVPN throughput.
- Improved USB tethering compatibility across various devices.
- Improved USB tethering for iOS by preserving trust data across reboots.
- Improved configuration changes to avoid interrupting client connections.
- Improved dashboard data accuracy during configuration changes.
- Improved system stability while scanning for WiFi Uplink candidates.
- Improved stability.
Bugfixes
- Fixed an issue where WiFi Uplink can’t be switched from a Secured SSID to an Open SSID.
- Fixed an issue where WiFi Uplink roaming scan might cause momentary latency.
- Fixed an issue where WiFi Uplink can't connect to WiFi 7 APs with SAE-EXT-KEY or SAE-H2E enabled.
- Fixed an issue where WiFi Uplink might prefer 2.4 GHz on cold-boot.
- Fixed an issue where LCM reports Internet Online but traffic is actually blocked.
- Fixed an issue where LCM does not display VPN icon when OpenVPN is connected.
- Fixed an issue where creating Secondary WiFi did not take effect.
- Fixed an issue where setting a static IP will force UTR offline.
- Fixed an issue where UTR could not be managed in the mobile app under heavy load.
- Fixed issues where OpenVPN might fail to be disabled, enabled, or recover an existing connection.
- Fixed an issue where OpenVPN might fail to connect due to a missing CA.
- Fixed an issue where USB Tethering failed to work after disconnecting WiFi Uplink.
- Fixed an issue where WiFi Uplink can’t connect after a configuration change.
- Fixed an issue where UTR would fail to roam occasionally.
- Fixed an issue where captive portal access was blocked by VPN Kill Switch.
- Fixed an issue where a recovery mode firmware upload did not clear the existing user configuration.
- Fixed an issue where the dashboard showed no connection while UTR was connected.
- Fixed an issue where connecting to a secured WiFi Uplink network failed after using an open network.
- Fixed an issue where UTR always used open networks for WiFi Uplink.
- Fixed an issue where UniFi APs could report UTR as a rogue AP.
- Fixed an issue where changing the Secondary WiFi configuration on UTR could affect the Primary WiFi.
- Fixed an issue where WireGuard could get stuck in a connecting state after being disabled.
- Fixed an issue where custom DNS settings were not always used.
- Fixed a DNS leak when VPN DNS overlapped with the UTR LAN IP.
- Fixed an issue where boot could get stuck if a firmware upgrade was interrupted.
Laatst bewerkt:
